First Attempt at Making Flat Moulds

 

First Attempt at Making Flat Moulds:

Step 1: take a small ball of clay and press it onto your surface to create a small circle or rectangle and blend the edges into the surface, getting it as flush to the surface as possible.

Step 2: create the main lines for example 2 edges for a cut or a circle for a bullet wound.

Step 3: use smaller balls in the centre of the sculpture and blend them then use your tools to add texture, add as much clay as you need to get it to the required depth.

Step 4: add texture to the outside of the clay using tin foil or a plastic bag to create the texture of skin.

Step 5: build a barrier about an inch away from the sculpture to hold the alginate in place while curing.

Step 6: pour the alginate or silicone over the clay to create the mould.



Step 7: Pour the plaster onto the alginate and allow to set, this can then be used to create prosthetics.

Comments

Popular posts from this blog

1990s Research

Prosthetics Making and Experimentation

1970s Research